>>Reply to John Moran:
>>You are right, there is a conflict in that the seat belt bolt is behind the
>>pulley, which is a niusance. IMHO it might be better if the plate was larger,
>>then the spacers wouldn't be needed and the rudder cable would be closer
to the
>>side of the console. Easier then to bury them in nylon tube bonded to the
>>structure.
>
>I plan to avoid the rudder cable conflict problem(s) by routing them in
>teflon lined bowden cable (using motorcycle rear brake cable stock) as far
>aft as the rear cabin bulkhead.
>
>Miles
May I suggest you use short lengths only, not a full length. Think of the
weight.... it all adds up.
Andy
|