>I find that the 3/8"-16 Nyloc nut which secures the top of the dampers to
>the reaction plate is too thick - 0.460 in - to clear the retraction arm
>even without safety threads protruding. Local stores don't carry a half
>height version and Aircraft Spruce doesn't list one for 3/8-16".
>
>I am hesitant to file it down so it fits since this will reduce the strength
>considerably given the amount which needs removal.
>
>So, how should this be handled?
>
>John A044
John,
The bolt in question is in shear and not in tension. It is therefore
acceptable if necessary to file down the back of the nut to gain the
necessary clearance.
Regards
Roger
____________
Address for Europa Aviation technical back-up is
enquiries@europa-aviation.co.uk
|