Hi! Lloyd again.
With regards to 'angle drill requirement, have you thought about a small
flexible drive cable? Only trouble is you could do with someone to operate
the drill switch! It wouldn't be the first time if a drill bit jammed then
the whole drill hits you round the back of the head !!!!!
Regards Bob Harrison 337 G-PTAG ptag.dev@ukonline.co.uk.
-----Original Message-----
From: GERAINT L OWENS [SMTP:lloyd.owens@lineone.net]
Sent: 09 March 1999 21:49
Subject: Angle drills
Thanks to all who responded re. my recent query on landing gear frame
distances. Not only was the info. a help; but all became clear when I
came
to do the job (as is so often the case). Here's another one:
Page 21-3 of the XS Fuse Manual calls for an angle drill to drill through
the upper tubes of the landing gear mounting frame. I rang around all
local suppliers and prices range from ?40 to ?80 for a right-angle drill
attachment for my Black ie. almost as much as the drill
costs. No-one carried these in stock either. It seems crazy to spend
this much on a one-off job. Has anybody any ideas? Can the job be done
another way? If not, can anyone recommend a source of supply in the UK?
Regards
Lloyd Owens
|