I placed my EIS temperature sensor in the radiator outlet hose. This is the
standard on MCR01's which are provided with a tapped insert specifically for
the sender.
Jerry
Flying Hi - Wish I was
jerry@flyinghi.demon.co.uk
-----Original Message-----
From: JohnJMoran@aol.com <JohnJMoran@aol.com>
Date: 10 March 1999 15:29
Subject: 912 Coolant Temp??
>I purchased an EIS for use with the 912S, so the CHT's will monitor the
>temperature of the coolant in the heads. However the EIS has a separate
>coolant temperature probe which is meant to monitor the coolant in the
system.
>I built a fitting for this coolant probe from 1 inch stainless which can be
>inserted into the 1 inch coolant hose. The question is, should it be in
the
>outlet hose from the engine (where it should more or less duplicate the CHT
>reading) or in the inlet hose from the radiators to the engine (where it
would
>monitor the effectiveness of the radiators)?
>
>John A044
|