When this same question was asked of CIBA they responded by saying that
there was no significant affect on mechanical properties at mix errors of
upto 5%. Except for aircraft use where they were not able to state a figure
(!). Triumph of the legal profession over engineering I suppose.
Duncan McFadyean
-----Original Message-----
From: Ed <bizzarro@easynet.co.uk>
Date: Thursday, August 05, 1999 6:37 PM
Subject: Redux mix ratio
>Hi everyone
>
>Does anyone know just how accurate the redux mix has to be. Is it as
>critical as the SP systems 1%, or will a basic home made measuring device
>(as shown in the manual for the epoxy) be good enough? Looking through the
>spec sheets, I don't see anything regarding this subject.
>
|