Jim Graham wrote:
> Would appreciate advice from the board...
>
> I'm looking for the correct fix for an air pocket that showed up after I
> did my first internal tailplane rib (on TP2 outboard side). Mostly the
> work turned out very nicely, BUT I ended up with a horrific bubble
> (about 1.5 inches long and maybe
> 3/8" wide) just alongside the plywood on the upper surface (not the
> surface that will be joined to TP3).
> snip
We all get these... drill a needle sized hole at each end, heat it gently
with a hairdryer or heat gun, and use something flat hard and cold to
flatten the bubble. Then inject in some epoxy, peel ply the holes if you
need to.
M
|