I guess those are them. <g> Thanks to all for the help, especially the reminder
to check the newsletter for the very answer I'd posed. Also thanks for the
reminder to write these gems down in the manual as soon as the newsletter
arrives! <shakes head> Of all the things I should rely on during this build, my
memory is not one of them.
Thanks gents,
Steve G.
ptag.dev@ukonline.co.uk wrote:
> Hi! Steve .
> I presume you mean the slotted holes for access to tighten the harness bolt
> and inspect the rudder cable pully's ?
> If so then they need to be about 5/8ths" wide and 2" long and positioned
> slightly forward of the pully location .and close enough to the pilot
> /passengers butt to engage a spanner on the harness bolt. (don't forget to
> rejion the two sandwich skins by removal of the foam and replacing with a
> wet flox mix.)
> Regards
> Bob Harrison Kit 337 Europa /Jabiru3300 G-PTAG
>
> -----Original Message-----
> Behalf Of Steve Genotte
> Subject: On to the fuselage!
>
> Gents,
>
> 53 weeks into the build now and we've started on the fuselage. I just
> marked out the cut lines in the cockpit module (feeling more like an
> Egyptologist trying to make out hieroglyphic tracings...boy those things
> are hard to find) but for the life of me I can't see any lines for the
> areas that correspond to the pilot's right hip and the passenger's left
> hip. I've tried all kinds of light, graphite, etc. to no avail. Any
> hints?
>
> Thanks for helping us get this far,
>
> Steve & Eileen G.
>
|