Hi! Steve .
I presume you mean the slotted holes for access to tighten the harness bolt
and inspect the rudder cable pully's ?
If so then they need to be about 5/8ths" wide and 2" long and positioned
slightly forward of the pully location .and close enough to the pilot
/passengers butt to engage a spanner on the harness bolt. (don't forget to
rejion the two sandwich skins by removal of the foam and replacing with a
wet flox mix.)
Regards
Bob Harrison Kit 337 Europa /Jabiru3300 G-PTAG
-----Original Message-----
Behalf Of Steve Genotte
Sent: Sunday, February 06, 2000 4:22 AM
Subject: On to the fuselage!
Gents,
53 weeks into the build now and we've started on the fuselage. I just
marked out the cut lines in the cockpit module (feeling more like an
Egyptologist trying to make out hieroglyphic tracings...boy those things
are hard to find) but for the life of me I can't see any lines for the
areas that correspond to the pilot's right hip and the passenger's left
hip. I've tried all kinds of light, graphite, etc. to no avail. Any
hints?
Thanks for helping us get this far,
Steve & Eileen G.
|