Brian,
I put most of my fuel lines in position, in the tunnel.
Fuel selector also in place.
Fuel pump goes on the baggage bulkhead port inner support at 45 degrees.
Yes, definitely cut a rough hole initially for the spars to allow the
aileron
bell cranks in place. Once module bonded in then cut out the holes to
size.
Fuel filters are under each seat pan, to give easy access.
Cheers,
Tim
Brian Rauchfuss - PCD wrote:
>
> I am about to put my cockpit module into the bottom and I am considering
> what I can get done before everything gets difficult to get at.
>
> I was thinking about putting in some of the fuel system bits, but I am not
> sure where things go. Where are the two filters mounted where they are both
> secure and easily viewable from the inspection ports? Where is the fuel pump
> usually mounted? How do you route the fuel lines through the tunnel?
>
> Another thing I was thinking about doing was cutting the side holes in the
> fuselage for the spars and aileron controls before I glue to module in, this
> will prevent the aileron control from pushing the skin out slightly. Is this
> a good idea?
>
> Brian
--
Timothy P Ward
12 Waiwetu Street,
Fendalton,
Christchurch,
NEW ZEALAND
Ph. 0064 03 3515166
email ward.t@xtra.co.nz
Mobile 025 2649325
|