<< To those fortunate builders that are now flying, have you found it
necessary to have a rudder trim tab? If so, what did you use? >>
Erich,
yes, i put a piece of thin sheet stainless steel about 5x2 inches, with
some holes drilled down the middle to assist the bend.Floxed on, painted
white. Applies a bit of left rudder.
'UM is set up for solo flying at 112kt ias (fixed warp drive, 80hp rotax),
depending on passenger size it can make a big difference to trim at different
speeds.
chus,
dave,
kit67
|