flying <paul-d.stewart.fly@virginnet.co.uk>
> Trimming the extra material from the rear of the cockpit module is a very
> good idea. I blindly followed the manual only to realize when it was time
> to install the baggage compartment bulkhead that it was rather tedious to
> make the required cut after bonding (especially since some of it was bonded
> to the fuselage sides!)
>
>
> Best regards,
>
> Rob Housman
> A070
How do you know where to trim here? This is the only place I couldn't find
any trim lines. I was planning on trimming it when I could put the top on
and be sure that I was cutting it right.
Brian
> You need to trim off a portion of the rear of the module which I don't
> believe is in the current manual yet. If this section is not trimmed before
> gluing, it will have to be trimmed later to put in the baggage compartment
> bulkhead. I can send you a picture of this area trimmed if you wish.
> I felt the same way about the spars clearance. Hopefully I won't discover a
> problem later.
> Good luck,
> Bill McClellan
> A164
|