Have a look at my builders log at http://www.kaon.co.nz/europa/272i.html I
documented a method using some plastic waste fittings.
Tony
-----Original Message-----
From: owner-europa@aztec.houxou.com
Subject: Pip Pin Holes
Folks,
I am just thinking about cutting the holes in the tailplane for the pip pins
and I was wondering if anyone had some up with a way of sealing the hole so
that it does not disturb the airflow. I was thinking of putting in some
sort of screw thread with a screw-in cap, or perhaps a push-in plastic cap.
Any ideas would be gratefully received.
By the way, thanks to everyone who has responded to my past questions.
Hopefully I will soon be in a position to answer some questions rather than
asking them all the time!
Thanks
Rick
|