Hi! Nic.
Those on G-PTAG don't stick out into the 'stream thank you "good buddy!"
Great minds think alike they are the same as Tony Krzyzewski's
without collusion ! Might be a bit heavier than tape though but more vandal
proof ! Sorry I haven't got a max.straight and level speed yet, but I am
about to address that omission.!
Regards
Bob Harrison PTAG
> -----Original Message-----
> From: owner-europa@aztec.houxou.com
> Subject: shear pin cover
>
>
> I was most surprised to see my fastbuild tailplanes w/ hideous protruding
> covers.
> They are shiny inside-threaded outside-beveled ring collars ?
> that stick up
> nearly a quarter inch.
> They have a threaded disk with a two-hole wrenchpin pattern.
> They are on the control surface hinge side - the top?
> I am at a bit of a loss as to how to streamline or grind them off or reset
> them flush.
> Mebbe first cut them out and then reset them flush.
> Tape is sounding good.
> Red on the left, green on the right.
> Maybe they're required for inverted spin recovery.
>
> Listening
> Nic xs-145
>
>
|