Hi! Chris A159/Sue.
Don't know about the head sets but try black plastic bin liner to lay up on
that way you can see if you left any in your construction and also you can
get to be really lean with the amount of epoxy you apply, since you can
watch it suck into the glass fibre and just put the odd dab in overlight
places.
Regards
Bob Harrison G-PTAG Europa/Jabiru 3300
> -----Original Message-----
> From: owner-europa@aztec.houxou.com
> EuropaChris@netscape.net
> Subject: Headset recommendation?
>
>
> As a side note, we finally started on the wings over the past
> month. For the rib/skin reinforcements, Sue had the idea of
> laying up a large section of bid on plastic wrap, say 2' wide cut
> at 45 deg. and then layup the second layer on top of that, and
> then just cut 2" strips, rather than trying to work with
> individual 2" strips that never keep shape and fray badly. Other
> than trying to work with too large a section of glass at one
> time, the idea works incredibly well. Just whack off a full
> length of 2" wide bid, and cut to length as you need it. The
> only suggestion I would make is to only layup 1' wide and then do
> a second layup. Fortunately, our basement is about 62 degrees,
> so it gave us enough working time with the glass. After we were
> done, I put heat lamps and a small electric heater near the wing
> to keep the temp around 70 for 24 hours.
>
> Now to figure how to mount those Aeroflash strobes in the wing tips...
>
> Enjoy!
>
> Chris
> A159
> http://webmail.netscape.com/
>
>
|