Bill,
>the engagement pin(s) on one side of
> the tailplane have become slightly misaligned. this >prevents the tailplane
sliding on cleanly. i tried >tweaking the pins ever so slightly but without
> improvement.
you need a tube of alloy, or a rod, about 12 inches or so long, with a hole in
the centre the same diameter as the pins. Slide the rod onto the pin and as
long as it is a good tight fit it will point in the direction of mis-alignment.
To re-align, simply use the rod to 'tweak' the pin until it lines up with the
torque tube - can be done by eye quite easily.
dave
kit67
|