"Tony S. Krzyzewski" wrote:
> You'll need to trim the edges to get a tidy join when the two parts
> overlap. Believe me, a 1" overlapped joint glued with Redux is going to
> be so strong you'll never have to worry about it. Keeping the joint to
> the required size is also going to save you the weight of the extra edge
> plus the weight of the Redux.
> ....
Not to mention that Redux is hideously expensive if you run out!
I would add that you should leave some extra flange on the
forward-facing, vertical portion back near the fin. If you can't pull
the top back quite far enough, you'll need it. Just in case, of
course; all Europa parts are a perfect fit, right? :-)
Regards,
Fred F., A063
|