>I understand that the main 6 instruments are best served by a hole 3.16
>inches, just larger than 3 1/8.
>
>Spruce have a 3 1/8 hole cutter which I'm sure will do the job.
The 3.125" holesaw available for loan to Europa Club members is a
tungsten carbide grit type, so is unsuitable for use on aluminium
(I've tried it without success). It works fine on GRP, though.
Does anyone know if there are any of the water-jet or similar cutter
shops in UK?
regards
Rowland
| Rowland Carson Europa Club Membership Secretary
| Europa 435 G-ROWI PFA #16532 EAA #168386
|