By the way, how did you fit the tire (and one assumes, the landing gear
assembly) before the hole was cut?
Shaun
>
----- Original Message -----
From: "Cliff Shaw" <flyinggpa@attbi.com>
Subject: Re: Big gaping hole?
> Steve
>
> I just did that job on my plane, ( N229WC "Wile Coyote" ), a month ago. I
> cut smaller than required and then mounted the tire and carefully cut
until
> I had a half inch clearance. The brake sticks out to one side quit a ways.
> By doing it this way, "to fit", I will not have to rebuild places like I
> did on Bob's "Beep Beep" .
>
> Cliff Shaw
> 1041 Euclid ave.
> Edmonds WA 98020
> (425) 776-5555
> A229 N229WC "Wile Coyote"
>
>
|