Hi! Kevin.
Hopefully you are doing a "dummy" run of fitting the cockpit module and
using clecoes at regular intervals? Then on the final fit self tap
screws/light pop rivets in the same holes used for the clecoes as pairs,
if everything aligned to the recommended dimensions on the "dummy" run then
it will when you go for the final fit?
Don't forget the tip to shine a light behind the reduxed joints to show the
adequate layer of Redux along all the joints so you don't pull them together
too tight .
Regards
Bob harrison G-PTAG
-----Original Message-----
From: forum-owner@europaclub.org.uk
Subject: Cockpit Module
HI all, I'm trying to figure a way of insuring the 323mm spacing between
the bottom of the seat back and the baggage bay front bulkhead when bonding
the module in place. It was held to the dimension when the fuel tank went
in. There must be an obvious and easy way that I am not seeing.
Thanks, Kevin A211
|