Hi! Cleve
Mine on G-PTAG has been approved at the top of the fin, but I also have one
on the belly.
Regards
Bob Harrison G-PTAG
-----Original Message-----
From: forum-owner@europaclub.org.uk
clevelee@cswebmail.com
Subject: Re: Position lights - wires after the fact
Thanks for the suggestions folks -
Mounting he strobe on the fin had occurred to me, but I was concerned that
the line of sight of top of the cabin is less than 30 degrees from a light
mounted on the top of the tail. Is the PFA approving this installation in
the UK?
Re. pulling new wires with the original - well, they are pretty well bonded
and strain relieve into place!
Cleve
A198
On Fri, 08 February 2002, "Fergus Kyle" wrote:
>
> Cheers,
> Subject: Re: Position lights - wires after the fact
>
>
> > Put a single strobe on the tip of the fin!>
> ...unless you have installed the vertical halfwave dipole in the rudder
> closeout. The grounded wire might skew the VHF signal some. ...and I had
> plans for that fin top!
> Happy landings
> Ferg
>
>
The ALL NEW CS2000 from CompuServe
Better! Faster! More Powerful!
250 FREE hours! Sign-on Now!
http://www.compuserve.com/trycsrv/cs2000/webmail/
|