Richard and All
I have done this job and did get a small bind at extreme starboard roll.
It was caused by a slight misalignment of the flange to the bulkhead at the
front end . I did not think I tightened the bolt too tight , but I did.
Your idea of the spacer that is removed would have helped in my case.
My advise is to make the Redux / flox square up the mounting and don't pull
it out of alignment with the bolts . Only tighten them after the Redux is
hard.
Cliff Shaw
1041 Euclid ave.
Edmonds WA 98020
(425) 776-5555
N229WC "Wile E Coyote"
|