06/07/2002 01:26:04 PM,
I hope the forum is up and running again
I'm about to drill my wing plates, the classic manual indicates the hole
is centred in the plate, the XS fuselage manual drops it 1/2" below the
centre, but the diagram still shows the hole centered - before I do
something I might regret, can anyone confirm that the holes are now below
the centreline.
On the subject of hinge pin bending, I found bending one end in a vice,
then inserting an overlength section of pin in the hinge and bending this
with a tube with an inside diameter similar to the pin worked, then I cut
the overlength section of the pin off
Dave A061
|