12/16/2002 09:51:37 AM
Hi All,
The tail vent was based on the assumption that that surface is a high
pressure area.
A scat hose pulls off the vent loops back towards the rostral part of the
airframe. I put a
plywood support for the hose on the top of the pitch support bulkhead and
---From there to
a fiberglass conduit on the ceiling of the fuselage. The conduit is
glassed to a passage
through the rear reinforcing support between the doors and into the space
between the
hinges where the outlets are located. The conception and basic design were
per FlightCrafters (www.flightcrafters.com)
Ira
N224XS XS Trigear MG (90% done, 90% to go!)
|