What about two straight edges of wood or whatever, placed top and bottom,
spanning the tailplane and tab held by clamps while you drill smaller than
necessary holes to begin with then opening them up to the right size? (hows
that for a run-on sentence)
Troy Maynor
-----Original Message-----
From: Andrew Sarangan <europa_builder@yahoo.com>
Date: Monday, December 16, 2002 11:21 AM
Subject: Attaching trim tab
>
>With the hinges attached to the trim tabs, is there a good way to clamp
these hinges to the trailing edge of the tailplane while drilling holes for
the bolts? The way the tailplane and trim tabs fit together, there doesn't
seem to be any room for using clamps. Suggestions appreciated.
>
>
>---------------------------------
|