Hi! Tony.
The Ray Allen Company who make the Trim Servo and Relay Deck have the
necessary device which will slow down the trim. But You would probably have
to research an "either or" system or switch.
I get on quite well with the system initially provided fast or slow.
Regards
Bob Harrison G-PTAG
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of Tony Renshaw
Subject: Europa-List: 4 position rocker switches for trim
Hello,
I am thinking about using a multi function rocker switch should I choose to
use the MAC Servo Speed Control. I want a switch that if I 1/2 depress it
either for nose up or down, well I get 1/2 rate. This rate would actuate
the Servo Speed Control circuitry and would be suitable for high speed
cruising. Then I want to be able to fully depress the switch to get a
faster rate in either direction. I have tried to research the net, but
switches is a bit of a minefield if you are not electically minded. I have
tried Spruce to no avail and would like to request advice on the
applicability or otherwise of my switch idea, and where I would get them.
Lastly, I would like to know if anyone else has used this Servo Speed
Control and if so, was it co located with the servo on the rear bulkhead?
Thanks.................
Reg
Tony Renshaw
|