Thanks for the responses Bob,Cliff,Kevin and Ferg on fuel line requirements.
What a great help the Europa family is!
craig
----- Original Message -----
From: "Robert Berube" <bberube@tampabay.rr.com>
Subject: Re: Europa-List: Re: Fuel line requiremnets for Rotax
<bberube@tampabay.rr.com>
>
> Craig,
> The minimum for the 914 is 5/16 ID which is included with the firewall
> forward kit. If you are planning on using aluminum fuel lines with AN
> aircraft fittings, you will need to go with 3/8 ID since 5/16 AN flare
> fittings are generally not available.
> Regards,
> Bob Berube A166 Conventional
> ----- Original Message -----
> From: "craig ellison" <craig.ellison2@verizon.net>
> To: <europa-list@matronics.com>
> Subject: Europa-List: Re: Fuel line requiremnets for Rotax
>
>
> <craig.ellison2@verizon.net>
> >
> > All, There was a question a few days ago concerning the fuel line
> > requirements for Rotax 912, 912S, and 914 engines. I didn't see any
> > responses . I'm fitting out my fuel system now for a 914 and have run a
> 1/4
> > " ID versatube line from the firewall back to the fuel pumps. Is this
> > adequate? Or should it be 3/8". Any advice from those who have gone
> before
> > much appreciated. Thanks
> >
> > craig ellison
> > a205
> > silverton, or
> >
> >
> > ----- Original Message -----
> > From: "Tony S. Krzyzewski" <tonyk@kaon.co.nz>
> > To: <europa-list@matronics.com>
> > Subject: RE: Europa-List: Pip-pin wanted
> >
> >
> <tonyk@kaon.co.nz>
> > >
> > >
> > > >
> > > > By 'upgrading' I mean the process by which some people have changed
> > > these
> > > 1/4" pins to 5/16" pins and reamed out the holes accordingly -
> > > 'oversizing'
> > > you call it.
> > >
> > > David,
> > >
> > > You've got a crossed message here...
> > >
> > > The pip pins, as you correctly describe, are used to hold the
> > > stabililators to the torque tube.
> > >
> > > The oversizing has not been done to these but to the pins within the
> > > body of the aircraft holding the central parts of the torque tube
> > > together. As you will see, these pins are retained with split pins and
> > > are therefore referred to as permanent pins.
> > >
> > > Tony
> > >
> > >
> >
> >
>
>
|