Hi Gerry,
Take a look at Skydrive kit for water temperature. It is very cheap, passive
VDO probe (same as
is used by Rotax for CH), goes directly into one of the water hoses on top
of the engine and
is easy to install. I use an EIS, but other instruments should be fine also.
Regards, Karl
>From: Gerry Holland <gnholland@onetel.com>
>Reply-To: europa-list@matronics.com
>To: <europa-list@matronics.com>
>Subject: Re: Europa-List: Static Charges and how to avoid them
>Date: Tue, 27 May 2003 19:13:36 +0100
>
>
>Hi! to all.
>
>After much deliberation about Engines I have fitted a Rotax 912 with
>Arplast
>PV50 Prop. and CS Controller. Tri-gear now stands on it's three legs!
>
>I had not taken account or thought about Water Temperature or maybe a Water
>Pressure Gauge too but it would seem sensible to monitor. I would like some
>advice or experiences on fitting 'steam Gauge' type indicators and where
>the
>sensor should or could be positioned. Should a mechanical Water Temperature
>Gauge considered.
>
>Regards
>
>Gerry
>
>Gerry Holland
>Europa 384
>G-FIZY
>+44 7808 402404
>gnholland@onetel.com
>
>
http://www.msn.co.uk/messenger
|