Now it mightn't have been to Smart to ask a question about a SmartTool with
court jesters lurking.............but I have looked to see if there are any
instructions "On" the level. I used to keep the instructions buried within the
level, in the battery compartment, but I must have been remiss at returning
them after use. Its not such a big deal, simply I am wondering at what point it
is appropriate to move the level after it displays "Calibrate 1". It flashes
the whole time until you repress calibrate, which is a bit incongruous if it is
taking a reading. One might choose to think that it would stop flashing once it
had made its first registering of the level. I have left my guard down to be
asking questions about a SmartTool.........maybe there is a message there ;-)
Reg
Tony Renshaw
Sydney Australia
>
>Hi! Tony.
>I've lent my unit out but I'll be surprised if the method isn't printed on
>the side of the unit?
>Try going to bed earlier!
>Regards
>Bob Harrison G-PTAG
>
>-----Original Message-----
>From: owner-europa-list-server@matronics.com
>[mailto:owner-europa-list-server@matronics.com]On Behalf Of Tony Renshaw
>To: europa-list@matronics.com
>Subject: Europa-List: SmartTool Calibrating
>
>
><tonyrenshaw@optusnet.com.au>
>
>Gidday,
>I seem to have misplaced my instructions and was wondering if someone could
>remind me how to calibrate it. It shouldn't be hard, just press the
>Calibrate button, press hold, turn it through 180 degrees, press Calibrate,
>then press Hold, and that should be that. Well I think I have forgotten a
>step or two, or maybe added one with the hold button. Suffice to say, I
>need a brain awakener. Standing by....................................
>Reg
>Tony Renshaw
>
>
|