Tony,
Here you go, per the manual.
Place level on flat surface. Wait 10 seconds. Push and hold the Calibrate
button for 2 seconds, CAL1 will appear on the display. Rotate end for end.
Wait 10 seconds. Push Cal button again, Cal2 will appear. You are done.
Ralph
Motorglider
Reno, NV
----- Original Message -----
From: "Tony Renshaw" <tonyrenshaw@optusnet.com.au>
Subject: Europa-List: SmartTool Calibrating Cont'd
<tonyrenshaw@optusnet.com.au>
>
> Now it mightn't have been to Smart to ask a question about a SmartTool
with
> court jesters lurking.............but I have looked to see if there are
any
> instructions "On" the level. I used to keep the instructions buried within
the
> level, in the battery compartment, but I must have been remiss at
returning
> them after use. Its not such a big deal, simply I am wondering at what
point it
> is appropriate to move the level after it displays "Calibrate 1". It
flashes
> the whole time until you repress calibrate, which is a bit incongruous if
it is
> taking a reading. One might choose to think that it would stop flashing
once it
> had made its first registering of the level. I have left my guard down to
be
> asking questions about a SmartTool.........maybe there is a message there
;-)
> Reg
> Tony Renshaw
> Sydney Australia
>
>
<ptag.dev@ukonline.co.uk>
> >
> >Hi! Tony.
> >I've lent my unit out but I'll be surprised if the method isn't printed
on
> >the side of the unit?
> >Try going to bed earlier!
> >Regards
> >Bob Harrison G-PTAG
> >
> >-----Original Message-----
> >From: owner-europa-list-server@matronics.com
> >[mailto:owner-europa-list-server@matronics.com]On Behalf Of Tony Renshaw
> >To: europa-list@matronics.com
> >Subject: Europa-List: SmartTool Calibrating
> >
> >
> ><tonyrenshaw@optusnet.com.au>
> >
> >Gidday,
> >I seem to have misplaced my instructions and was wondering if someone
could
> >remind me how to calibrate it. It shouldn't be hard, just press the
> >Calibrate button, press hold, turn it through 180 degrees, press
Calibrate,
> >then press Hold, and that should be that. Well I think I have forgotten a
> >step or two, or maybe added one with the hold button. Suffice to say, I
> >need a brain awakener. Standing by....................................
> >Reg
> >Tony Renshaw
> >
> >
>
>
|