Would appreciate input on Rib Mutilation.
Have some thin wall, bout 1 inch OD Irrigation tube that I want to run in wing
to plumb wires to tip and run static/airspeed hose through and stall warning
indicator
hoses/wires..
I can cut a 1 inch hole and just let the plastic tube lay on the ribs.
Or can put a few dabs of silicone at the joint.
Also have some perfect fitting grommets, but that would require cutting a larger
hole by probably 1/8 inch.
Would it be recommended to reinforce rib, lets say with a BID Patch prior to
cutting
hole, especial if using grommets?
Thx.
Ron Parigoris
A-265 monowheel
|