Paul
We were told all round - including the horizontal bit. I think I asked
Andy or Nevill the same question.
Regards
Paul Stewart
Paul Mansfield wrote:
>
>Does any Bid get laid up from the horizontal floor to the fuselage sides?
>
>P.28-11 just says "Also layup 2 plies of 'bid' each side of the join between
>the fuselage and the rear baggage bay bulkhead, lapping them onto each by
>25mm (1")."
>
>Not sure if that includes the horizontal portion...
>
>Thx
>
>Paul 383 Mono XS
>CM in, working on bottom(!)
>
>
>-----Original Message-----
>From: Neville Eyre
>To: europa-list@matronics.com
>Subject: Re: Europa-List: Baggage Bay Questions
>
>Hi Mike,
>The baggage bay floor sits 3/4'' [19mm] above the tailplane pushrod, at the
>same angle, put a piece of scrap timber that thick on top of the pushrod,
>and trim the outer edge of the floor, and the rear bulkhead so there is no
>pressure on to the inside of the fuselage. Then bond in with Redux under the
>overlapping flange to the lower bulkhead, and 2 ply Bid from the panel to
>the fuselage, [ both sides of the upper ''D'' shape bulkhead.] Cheers, Nev.
>
>
>
>
|