I'm in the process of installing the hardware in the starboard wing, and
am a little stumped. The manual calls for opening a 1/4" hole, near the
main pin bushing, closest to the first wing rib, that is suppose to be
covered over. This hole is to mount the quick connect bellcrank. My
assumption is that the hole should be above the centerline of the
bushing and to the rib side. I measured the dimensions, given in the
manual, and drilled a small pilot hole, hoping to find the factrory
drilled hole. I didn't find any open hollows, that indicated that there
was an existing hole. My question is, before I drill the larger hole
and counter bore, am I drilling in the right place? Thanks for any
clearification...
--
Jeff
Tri-Gear N55XS
|