The distance from the bolt to the hinge pin needs to be the same on both
ailerons so they deflect the same amount when installed. If one bolt has a
small tilt to it, are they really both the same distance to the hinge pin?
Kevin
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com]On Behalf Of Andrew Sarangan
Subject: Europa-List: aileron closeout question
During the closeout, the bolt placement turned out
fine and the distance from the LE and hinge lip was
almost exact. However, when I left it for curing, I
had not noticed that the A2 plate was not exactly flat
on the foam. One end of A2 is about 2 mm proud of the
foam surface. I would not have noticed it except for
the fact that the side flanges were a little
transparent and you can see the A2 plate inside. I
suspect the bolt has a small tilt too, although I
can't see it with the eye. Any ideas what this is
going to do to the aileron alignment?
__________________________________
http://promotions.yahoo.com/new_mail
|