Hi Dave.
Look at the chapter Nine photos at the site listed below my name. According
to Nev at the factory you should carefully remove the brown foam from the
inside of the bottom wing skin to allow the horn cover to align properly. Be
careful not to cut through the outer Fiberglas skin! I ground mine away with a
Dremel tool. Once this is done lay 2 ply of Bid on the surface to strengthen
and peel ply to smooth it all out.
Hope that helps
Brian S
A276 Tri Gear. Texas
See my build photos at:
http://forum.okhuijsen.org/BrianS
|