Gidday,
I am wondering how I am going to get my control stick wiring past the pivot
bolt that supports the Control Column Bottom Fitting? The wiring is
bundled, and is larger than the voids either side of the pivot bolt. I am
wondering if I can drill through the portion immediately below the tufnol
insert that surrounds the base of the stick? I would drill it such that the
wires would come out in an aft direction, and then through an access in the
front vertical face of the thigh support. So, has anyone else done this and
care to make any recommendations? All help greatfully received.
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig, and module most recently installed.
Tail Torque Tube installed.
Mass Balance assembly installed and deflections sorted
Roof Panel between doors completed.
Photos at:
http://forum.okhuijsen.org/TonyR
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
Horizon, one that I can trust for short periods IMC, to get out of a sticky
situation
|