Hi All,
In re-reading my posting of yesterday, I find an error which I would like to
correct as follows:
I wrote:
> To sum up, looking at McMaster-Carr catalogue pg. 3088, you find a picture of
> the aluminum "T" handle type "G" quick release pin; this APPEARS to be EXACTLY
> like that supplied w/ kit. Going to pg. 3089, you find part #90293A415 which
> is a "T" handle pip pin w/ 2 balls of 1/2" Dia. w/ 3 1/2" grip range at $29.30
> ea.
What I intended and should have written was:
"looking at McMaster-Carr catalogue pg. 3088, you find a picture of the
aluminum "L" handle type "D" quick release pin; this APPEARS to be EXACTLY
like that supplied w/ kit." On pg. 3089, you will find it listed as part
#90302A415, a 1/2" dia. pin w/ 2 balls and a 3 1/2" usable length for $33.27
ea.
You will also find a picture of the aluminum "T" handle type "G". Going to
pg. 3089, you find part #90293A415 which is a "T" handle pip pin w/ 2 balls
of 1/2" dia. w/ 3 1/2" usable length at $29.30 ea.
For those with a "hammer to fit" situation, the heavy duty 2 ball quick
release pin, part #90980A555 which has a welded steel "T" handle at $57.08
each, a 2 ball 1/2" pin w/ a 3 1/2" usable length, may be just the ticket.
Sorry for any confusion...now back to mix some resin!
Happy building,
Fred
A194
|