Gidday,
I am wondering if anyone who has done the mod to increase the size of the
pins that hold on the tailplane drive pin plates, called TP12, have had any
problems with the new 3/8" pins and looseness??
Reg
Tony Renshaw
Sydney Australia
Classic 236 B.B. Taildragger
Currently working on Rudder Pedals,
In but tight so more work to go on them.
Tail, Wings, Ailerons, Flaps Complete and Connected
Lower Fuse in Jig,
Tail Torque Tube installed with temporary timber dowels.
Mass Balance assembly installed and deflections sorted
Roof Panel between doors completed.
Photos at:
http://forum.okhuijsen.org/TonyR
Intended Engine: 912S CS prop (model undecided)
Instrumentation: Garmin 296 Colour GPS beneath an electronic Artificial
Horizon, one that I can trust for short periods IMC, to get out of a sticky
situation
|