This most likely won't make you feel better, but mine did the same. ;(
and I just made it work.
Ralph
DuaneFamly@aol.com wrote:
>
>Good day All,
>
>I have been putting the top on and off several times now to get things just
>right. One thing that I have noticed is that while all the horizontal epoxy
>joints seem to line up, the joggle joint doesn't seem to be fully overlapped.
>With all things in set, the front lip to the firewall clecoed in place, and
>the trailing edge of the fin lining up, I still get only about a 60% overlap
>in the joggle area. That's about a 3/8" (10mm) gap that does not provide
>strength. Have others had this problem? Is it a problem? Getting closer to
>bonding
>on the top and was just a little concerned.
>
>Mike Duane A207
>Redding, California
>XS Conventional Gear
>Just about to put the top on but still finding little things to do before
>that.
>
>
>
>
|