Thanks Nev! But I think I have found where the plies terminate. By
looking at the trimmed edges around the wing root, I found a place
where the plies changed thickness which gave away the location.
--- NevEyre@aol.com wrote:
>
> Hi Andrew,
> Don't waste time looking for the ends of the glass plies........
> Take the first ply of your rib / spar lay up into the radius of the
> stack of
> alloy plates [ make this one the long one on the spar].
> The second ply, the next shorter on the spar, should be 1/2'' [ 13mm
> in
> foriegn] shorter than the first, at the stack end.
> The third ply, [ the shortest onto the spar] should be 1/2'' shorter
> again at
> the stack end.
> Ensure you scuff into the radius with 80 grit, if the peel ply didn't
> go as
> far as that.
> Job done ! Have a good one !
> Cheers,
> Nev.
>
>
|