All,
Anyone out there using Bob Nuckolls Z-16 Rotax 914 wiring scheme?
I am using diagram Z-16 with OV unit supplied by B&C Specialty products. My
question is this: when wiring in the ammeter , where in this scheme would
you place it. The directions with the UMA unit say to place the shunt
between the voltage reg and the + side of the battery.
Thanks in advance for any and all responses.
craig ellison
a205
working on FWF
----- Original Message -----
From: "davebuzz" <davebuzz@aol.com>
Subject: Europa-List: Mod 70 Club view
>
> Some of you may be interested in the Club's view of Mod70. You can find
> this
> at:
>
> http://www.europaclub.org.uk/ in the 'News' pages.
>
> I realise it may not be what you wanted to hear, but in view of the seven
> complaints I received, plus a small number relayed through the Committee
> and
> noted on the list, we have certainly put some time into it, and I believe
> the Mod does the job in replacing what it does.
>
> It has been interesting to note a couple of comments on the list in
> favour
> of the Mod, and for us UK owners, I think we are lucky not to be in the
> position of those Shadow Microlight owners, who were grounded for months
> due
> to undercarriage problems and no one to support them. At least we have a
> Factory to support our plane.
>
> If anyone wishes to pursue this further, and perhaps requires a PFA mod
> number for the fitting of turnbuckles, then you can use mine:
> <<
> G-BXUM, kit67, PFA 247-12611, 'Additional cable Turnbuckles', Mod: M10028,
> dated April 1997: Turnbuckles in both TP18 cables, Bolted at the front
> onto
> the lugs with castle nuts and split pins.
>>>
> If this is you configuration then feel free to use it as a reference.
>
> All the best,
> dave
>
>
>
|