Craig
You want to read the current that your systems are using. It will go in
series in the line the supplies the main bus.
I just looked a Z-16, it shows the shunt in the line supplying the Bus after
the crowbar / OV device.
Good luck.
Cliff Shaw
1041 Euclid ave.
Edmonds, WA 98020
425 776 5555
http://www.europaowners.org/WileE
----- Original Message -----
From: "Craig Ellison" <craig.ellison2@verizon.net>
Subject: Europa-List: ammeter wiring
> <craig.ellison2@verizon.net>
>
> All,
> Anyone out there using Bob Nuckolls Z-16 Rotax 914 wiring scheme?
> I am using diagram Z-16 with OV unit supplied by B&C Specialty products.
> My
> question is this: when wiring in the ammeter , where in this scheme would
> you place it. The directions with the UMA unit say to place the shunt
> between the voltage reg and the + side of the battery.
>
> Thanks in advance for any and all responses.
>
> craig ellison
> a205
> working on FWF
> ----- Original Message -----
> From: "davebuzz" <davebuzz@aol.com>
> To: <europa-list@matronics.com>
> Subject: Europa-List: Mod 70 Club view
>
>
>>
>> Some of you may be interested in the Club's view of Mod70. You can find
>> this
>> at:
>>
>> http://www.europaclub.org.uk/ in the 'News' pages.
>>
>> I realise it may not be what you wanted to hear, but in view of the
>> seven
>> complaints I received, plus a small number relayed through the Committee
>> and
>> noted on the list, we have certainly put some time into it, and I believe
>> the Mod does the job in replacing what it does.
>>
>> It has been interesting to note a couple of comments on the list in
>> favour
>> of the Mod, and for us UK owners, I think we are lucky not to be in the
>> position of those Shadow Microlight owners, who were grounded for months
>> due
>> to undercarriage problems and no one to support them. At least we have a
>> Factory to support our plane.
>>
>> If anyone wishes to pursue this further, and perhaps requires a PFA mod
>> number for the fitting of turnbuckles, then you can use mine:
>> <<
>> G-BXUM, kit67, PFA 247-12611, 'Additional cable Turnbuckles', Mod:
>> M10028,
>> dated April 1997: Turnbuckles in both TP18 cables, Bolted at the front
>> onto
>> the lugs with castle nuts and split pins.
>>>>
>> If this is you configuration then feel free to use it as a reference.
>>
>> All the best,
>> dave
>>
>>
>>
>
>
>
|