That's exactly what i done, no problems so far,
Ivor Phillips
XS486 London UK
CM Installed, rudder cables complete,
undercarriage fitted brakes working
flap tube fitted
wing lift pins fitted,tiebar fitted instrument
panel being finalised,
----- Original Message -----
From: <EuropaXSA276@aol.com>
Subject: Europa-List: Tri Gear rear gear socket installation.
>
> Tri Gear Builders and Riders:
>
> I'm beginning chapter 29 and reading instruction on location and drilling
> the hole for the rear legs. After the holes are drilled, the manual says
> you
> remove the 3 mm foam to the outer skin 1 1/2 inch around the out edge.
>
> Impossible task as the hole location will be is a narrow 32 mm from the
> back
> of the cockpit module. Certainly they must mean the area aft side of the
> holes edge and not all round.
> In addition cutting on the side wound go into the side piece of the lower
> baggage bay area.
> My assumption is to only remove the 3 mm foam that can be access by not
> compromising the cockpit module. Anyone disagree with that?
>
> Thanks in advance
>
> Brian Skelly
> Texas
> Europa # A276 TriGear
> See My build photos at:
> http://www.europaowners.org/BrianS
>
>
>
|