Yes, that's the way it works out. It's too close to the vertical in the
front to get that measurement. I just tested mine yesterday with a little
bounce and it held up great. No cracks anywhere. Of course it was a planned
test you know. It couldn't have been a mistake (hahaha).
Dean Seitz
A284
N284A
-----Original Message-----
From: owner-europa-list-server@matronics.com
[mailto:owner-europa-list-server@matronics.com] On Behalf Of
EuropaXSA276@aol.com
Subject: Europa-List: Tri Gear rear gear socket installation.
Tri Gear Builders and Riders:
I'm beginning chapter 29 and reading instruction on location and drilling
the hole for the rear legs. After the holes are drilled, the manual says
you
remove the 3 mm foam to the outer skin 1 1/2 inch around the out edge.
Impossible task as the hole location will be is a narrow 32 mm from the back
of the cockpit module. Certainly they must mean the area aft side of the
holes edge and not all round.
In addition cutting on the side wound go into the side piece of the lower
baggage bay area.
My assumption is to only remove the 3 mm foam that can be access by not
compromising the cockpit module. Anyone disagree with that?
Thanks in advance
Brian Skelly
Texas
Europa # A276 TriGear
See My build photos at:
http://www.europaowners.org/BrianS
|