Good Day All,
I'm working on my wiring layout and I have a little question for those
before me. I have come across a couple of terminal boards that are designed to
plug into perforated boards. The pins extend straight down from the terminal
board approx. 5/8" (15mm) from it's underside. Does anyone see any problem with
me drilling two series of seven small holes in a line and then backfilling
with heat resistant sealer? I could then solder the connections on the engine
side going to the oil temp and pressure, CHT's, EGT, ammeter, warning light,
starter switch, etc. In order to remove the panel I would simply unscrew from
the terminal boards.
This would save from having to cut a large hole for a round bulkhead
connector...not to mention the expense.
Mike Duane A207A
Redding, California
XS Conventional Gear
|