torque tube drive pins
Paul
I did remove a pair once, (fortunatley before the top went on :-) ) and
they came out easily as soon as the nut was slackened. That was a
pleasant surprise. The tubing I used was the soft 1/4" stainless the
factory supplied for breather tubes etc. Had to drill for clearance to
get the bolts through. I used a sharp cobalt steel drill.
Graham
Paul McAllister wrote:
> Folks,
>
> So far (480 hours) I haven't had a problem with mine, but that doesn't
> mean I won't in the future.
>
> Graham Singleton made me couple of pins that have a tapered sleeve at
> each end that are designed to expand the stainless steel sleeve. I
> suspect that getting them off again would be difficult, however they
> look like that they would fix the problem and they are simple to make.
>
> Paul
>
> ------------------------------------------------------------------------
>
|