Gilles & all
I'm not familiar with 914 but I do remember that the return flow from
the regulator must be unrestricted otherwise the back pressure will
cause rich mixture? Because of the high flow rate required with all
pumps running the return pipe needs to be at least -6 size.
Hope I'm not confusing the issue
Graham
Gilles Thesee wrote:
> <Gilles.Thesee@ac-grenoble.fr>
>
> Simon Smith a crit :
>
>> That sort of dictates that
>> you should measure the airbox px and the carb inlet px (ie between the
>> regulator and the carb)....
>
> Hi all,
>
> The pressure on the upper side of the regulator (IN and OUT connections)
> is the fuel-to-carb pressure.
> The pressure on the lower side of the regulator is the airbox pressure.
> See installation manual or
> http://contrails.free.fr/engine_regul_en.php
>
> Hope this helps,
> Regards,
> Gilles
> http://contrails.free.fr
>
>
>
>
>
>
>
>
>
>
>
>
--
Graham Singleton
Tel: +441629820187
Mob: +447739582005
|