Nev
I have a vague memory that the bearing is not symetrical (back to front)
If put in wrong the spere will rotate, the oter way it is restrained by
the housing. Is this right, it's ten years since I last did this job??
Graham
NevEyre@aol.com wrote:
> Ramio,
> Ensure the spherical bearing is driven fully into the tube end fitting,
> if it is not all the way in, it will rotate as you have described, when
> fully inserted, the rotation should be limited so as not to '' go blind ''
> Cheers,
> Nev.
>
> *
>
>
> *
--
Graham Singleton
Tel: +441629820187
Mob: +447739582005
|