Craig
I can't think why not either, just be certain all three hinges are in
line which means care with initial fitting.
I don't quite agree with the manual here; at inital fit flox the hinges
on jigged to a straight extrusion and let the flox cure before pulling
the rivets because if you do that while the flox is wet you will
probably distort something.
Graham
craig bastin wrote:
I realise i need to dodge the sites of the mass balance arms, but
> other than that i cant see
> why i shouldnt do this now
>
> thanks
>
> craig
> 6:53 PM
>
>
>
>
>
>
--
Graham Singleton
Tel: +441629820187
Mob: +447739582005
|