He's right Willaim.!
When you set the incidence of the second wing, check the incidence at
the outer end of the flap on the first, then match the incidence of the
second wing at the same point to that. The incidence at the root doesn't
affect roll much but further out on the wing it does! That way you
compensate for any mismatch in the twist of the two wings.
Graham
William Daniell wrote:
> Ok thanks
>
>
>
> *From:* owner-europa-list-server@matronics.com
> [mailto:owner-europa-list-server@matronics.com] *On Behalf Of *Robert C
> Harrison
> *Sent:* Wednesday, May 07, 2008 16:13
> *To:* europa-list@matronics.com
> *Subject:* RE: Europa-List: Setting the wing incidence
>
>
>
> No! William .NO SLOT OUT OF ANY RIB, PLEASE. Just a scallop out of
> the close out air upper surface. The Rib is one of the most stressed
> items in the wing do not encroach into it.
>
> Regards
>
> Bob Harrison.
>
>
>
> -----Original Message-----
>
>
> Checked by AVG.
> 06-May-08 17:17
>
> *
>
>
> *
--
Graham Singleton
Tel: +441629820187
Mob: +447739582005
|