Jeff:
Make some guides out of Nylaflo tubing to run the cables through, for the
sides of the wheel well cavity. It is available through Aircraft Spruce.
Steve Hagar
A143
Mesa, AZ
> [Original Message]
> From: Jeffrey J Paris <jeffrey-j-paris@excite.com>
> To: <europa-list@matronics.com>
> Date: 6/21/2008 4:31:45 AM
> Subject: Europa-List: Question on rudder cable bearing location?
>
<jeffrey-j-paris@excite.com>
>
>
> Dear Thread,
>
> A quick question? I am in the process of running my rudder cables. I am
at the part of the instructions in which we fabricated the 20mm x 30mm
Tufnil blocks that are to be located on the plywood triangle seat support
ribs. When we place ours on the rib the cable ends up rubbing on the
inside walls of the console. If we make new and deeper blocks I'm
concerned with clearance of the landing gear (monowheel). Does anybody
have pictures or run into the same problem. I may have just place the
triangle rib supports a tad bit outboard than I should have.
>
> Thank you for your time and consideration.
>
> Cheers,
>
> Jeff Paris Kit # A012 Classic Monowheel
>
>
> _______________________________________________
> Join Excite! - http://www.excite.com
> The most personalized portal on the Web!
>
>
|